The Omega RDA clone is a high quality drip atomizer that is made out of stainless steel. This is a three post dripping atomizer, which means it can support single or dual coil builds. The top cap has three 3mm air holes and airflow can be adjusted by rotating the cap. It features a deep juice well that allows the user to fit plenty of wick in allowing a maximum dripping capacity.
- 1x1 replica
- Adjustable airflow with pre-drilled holes
- 510 Threaded atomizer connection
- Laser engraved logos and serial number
- Delrin insulated 510 connection
- Three phillips head screws for each of the three posts
- Stainless steel top cap and base
- Deep juice well
- 22mm Diameter (sits flush on most mods)
Due to the nature of this product, we will not accept any returns and/or exchanges. We inspect all products to ensure that they are defect-free and in working condition. These products do not have any manufacturer warranty against defects therefore all sales are final. These products are for experienced vapers and require technical knowledge of electronics to safely use it. This is because:
- Coils must be tested before use, if not the user could be harmed.
- RBAs are intended to be used on APVs and mechanical mods only.
- If not built properly, RBAs WILL ruin electronic devices if the coils are not made properly.
Please use the “Contact Us” page if you have any further questions.